Hit Finder

[Yanqui]

So except Panda Crazy that I cant really get my mind around it what other sources do you use to find good hits. I use HIT Scraper and they really seem to be a little compared to what you guys find in the daily threads.

Thanks!

 

[kryss]

So except Panda Crazy that I cant really get my mind around it what other sources do you use to find good hits. I use HIT Scraper and they really seem to be a little compared to what you guys find in the daily threads.

Thanks!

With HIT scraper or hit finder you might need to adjust your settings. I would recommend using hit finder over hit scraper. Hit finder is located within the MTS extension. The benefit of hit finder, is it logs hits you may have missed. A lot of people run hit finder at or under 5 seconds so they don't miss anything.

 

[Yanqui]

With HIT scraper or hit finder you might need to adjust your settings. I would recommend using hit finder over hit scraper. Hit finder is located within the MTS extension. The benefit of hit finder, is it logs hits you may have missed. A lot of people run hit finder at or under 5 seconds so they don't miss anything.

So it logs hits you miss and then you add them to Panda Crazy?

 

[kryss]

So it logs hits you miss and then you add them to Panda Crazy?

Right, it will save the panda for you in the log underneath:

You'll find the panda when you click on link in the "Accept" column.

 

[Yanqui]

Right, it will save the panda for you in the log underneath:

You'll find the panda when you click on link in the "Accept" column.

Thanks! So what are the best settings for Hit Finder, for surveys? I have 3 sec delay, min 0:50 cents.

 

[kryss]

Thanks! So what are the best settings for Hit Finder, for surveys? I have 3 sec delay, min 0:50 cents.

I'm not really sure what the best rate is when searching for surveys. I would say somewhere between 3 and 5 seconds might be a good search delay. You might be able to gain a few other insights by asking the daily thread.

 

[T. Leela]

Thanks! So what are the best settings for Hit Finder, for surveys? I have 3 sec delay, min 0:50 cents.

I have it set to worker.mturk in the advanced settings, and delay as 1 sec. only because it doesn't cause 'pre's when set to that site, and 1 sec bc you never know. I had .50 for surveys, and changed to .15 bc i decided smaller isn't necessarily a bad thing, but just personal pref.
Also, can't remember if you were the one asking abt batch settings sometime, my best settings for that is same as above, but 'most availble', no minimum $ amt set, TO at around 2.0, and with no pres to worry abt, i have both running.